2-way coaxial system
GLADEN ENA 165-X
- 165 mm 2-way coaxial system
- Integrated 13 mm tweeters
- 2 x 60 / 30 W (max / RMS)
- 4 Ω nominal impedance
- For use with a head unit or amplifier
Overview GLADEN ENA 165-X
The GLADEN ENA 165-X is a 165 mm speaker set with integrated tweeters. It is designed to replace factory speakers when you prefer not to install separate tweeters.
Each speaker combines both drivers in one unit, with the crossover already built in. You need just one mounting location and one speaker connection per side. The set can be powered directly by a head unit or a separate amplifier.
No separate tweeter installation
The tweeter sits centrally in front of the speaker cone. There is no need for an additional mounting location in the A-pillar, mirror sail panel, or dashboard. This also makes the ENA 165-X an option for vehicles without separate factory tweeter locations, provided the mounting dimensions and connections match.
Built-in crossovers
The connections between the woofer, tweeter, and crossover are already complete. There is no external crossover to accommodate and no additional tweeter cable to route.
Head unit or amplifier
The ENA 165-X can run directly from a head unit without a separate amplifier. If your system uses a separate amplifier, you can connect the speaker set to it as well.
Woofer
- Size: 165 mm
- Polypropylene cone
- Rubber surround
- Sheet steel basket with 7 spokes
- Ferrite magnet
- 25 mm voice coil
Tweeter
- 13 mm polypropylene dome
- Neodymium magnet
- Coaxial, centered in front of the cone
Technical data GLADEN ENA 165-X
Woofer
-
Re:
3,27
-
Sq:
134,8 cm²
-
Diameter:
165 mm
-
Power handling:
60 | 30 Watts
-
Impedance:
4 Ohm
-
Fs:
84 Hz
-
Qms:
4,73
-
Qes:
3,23
-
Qts:
1,92
-
Vas:
9,55 Liter
-
Mms:
9,87 g
Tweeter
-
Diameter:
13 mm
-
Impedance:
4 Ohm
-
Motor:
Neodym
Safety information and manufacturer details
Product name: GLADEN ENA 165-X 165 mm 2-way coaxial system
Product type: Loudspeaker (passive 2-way coaxial system for vehicles)
Item number: GA-ENA165-X
EAN: 4260242461267
Nominal impedance: 4 Ω
WEEE reg. no.: DE30475144
Safety information
- High volume can permanently damage hearing and stop you from hearing warning signals, sirens and spoken announcements.
- Fasten drivers and grilles securely and use all mounting points. When mounting in trim panels, check that the base can carry the load.
- Do not bypass or remove the tweeter's built-in capacitor. Operation without a high-pass filter destroys the tweeter and can cause failure.
- Magnetic field: keep a distance from implanted medical devices such as pacemakers.
- Choose the mounting location so that no displays or controls are covered and no airbag areas are touched.
- Installation only by suitably qualified persons. Before starting work, disconnect the battery as specified by the vehicle manufacturer.
- Do not mount in airbag deployment areas, in the driver's field of view or above the footwell or pedals.
- Do not work on high-voltage systems of hybrid and electric vehicles. Do not touch orange-marked cables.
- Only for dry interiors of road vehicles. Not for marine, trailer, outdoor or wet-area use.
Full safety and installation instructions: GLADEN ENA manual, via the QR code in the enclosed quickstart guide and under Downloads on this page. Product safety questions:
